:
from
to
Elastomer "G Body" Soft Control Trailing Arm Bushing Insert
SKU: SICGBTA109-100 22907
If you’re "G Body" General Motors Race or street car uses “stock” trailing arms, take a look at this part! Many racers and car crafters want the advantages of a monoball type insert, but are prohibited by rules or don’t like the noise, harshness or vibration of the monoball. Seals-it has solved the problem with a new Trailing Arm Bushing Insert for "G Body" cars! Using an Elastomer bearing, these parts replaces hard, deteriorated or worn out stock rubber bushings and provide movement like a monoball. This construction will satisfy many rule requirements requiring “rubber only”.
If your General Motors G-Body race or street car uses “stock” trailing arms, you need to take a look at this part! By using a softer elastomer bushing material in the upper control arms, you can significantly increase suspension travel and bite. This construction will satisfy many rule requirements requiring “rubber only” bushings.
Fits GM G-Body Metric chassis (1978-88 Monte Carlo, Regal, etc.)
IMCA approved for Southern Sport Mods only.
If you’re "G Body" General Motors Race or street car uses “stock” trailing arms, take a look at this part! Many racers and car crafters want the advantages of a monoball type insert, but are prohibited by rules or don’t like the noise, harshness or vibration of the monoball. Seals-it has solved the problem with a new Trailing Arm Bushing Insert for "G Body" cars! Using an Elastomer bearing, these parts replaces hard, deteriorated or worn out stock rubber bushings and provide movement like a monoball. This construction will satisfy many rule requirements requiring “rubber only”.
SOLD EACH.
Many racers and car crafters want the advantages of a monoball type insert, but are prohibited by rules or don’t like the noise, harshness or vibration of the monoball.
Seals-it has solved the problem with a new Trailing Arm Bushing Insert for "G Body" cars! Using an Elastomer bearing, these parts replaces hard, deteriorated or worn out stock rubber bushings and provide movement like a monoball. This construction will satisfy many rule requirements requiring “rubber only”. (Be sure to check your local rules BEFORE ordering!)
The parts constructed with an alloy steel housing and inside sleeve, and are bonded and molded using Seals-it’s proprietary process that is known by racers all over the world!
Fits GM G-Body Metric chassis (1978-88 Monte Carlo, Regal, etc.)
IMCA approved for Southern Sport Mods only.
Specs
Material Type: Steel
Overall Length: 2.30
Sold in Quantity: Each
Hole Diameter: .5
Diameter Small End : 1.850
Diameter Big End: 1.923
