Home - Race Day Tools & Pit Equipment - KOUL TOOL HOSE ASSEMBLY TOOL

KOUL TOOL HOSE ASSEMBLY TOOL

KOUL TOOL HOSE ASSEMBLY TOOL
LARGE 1016 KIT FOR AN10-16
SKU
KTXXX
Weight
4.00 lbs
Market price:
$99.99
Our price:
$75.00
25%
Click here to be notified of price drops of this item
 
CHOOSE SIZE
Qty

LONG OVERDUE-NO MORE HOLES POKED IN YOUR FINGERS!
      Since the invention of stainless braided rubber hose, racers and mechanics have been fighting the problem of installing it into the socket part of the assembly. If your lucky and get a clean cut on the end of that hose, you might get it in. Most of the time a little fuzz appears on the hose end and the battle begins. It is not only time consuming, it can get bloody. KOUL tools has delivered a solution that makes the assembly a snap. Manufactured of a high tech composite, it is virtually indestructible. No need to worry about vise marks or wearing out. Just insert the socket into the tool, twist the hose in, and in less than 10 seconds you have it assembled. You can repeat this several times without recutting the hose end. The tool can pay for itself the first time you don't have to scrap some hose because it got too short trying to clean up the end. You'll be amazed at the amount of time you'll save. After using this tool, you will say to yourself, "KOUL".

The small kit contains the capsules to install -4, -6, -8 hose into their respective sockets. To accommodate all the different manufacturer’s fittings, spacers and sleeves are required to tighten up the some of the sockets within the capsule. For the tool to perform at its best, the socket needs to be a snug fit in the funnel. The two spacers are used in some -6‘s and 8‘s. If the socket seems loose in the tool, use a spacer to tighten it up. In the small kit, only the Russell -4 needs a sleeve. Not for use with Teflon-style hose. #468.

 

The large kit contains the capsules to install -10, -12, -16 hose into their respective sockets. To accommodate all the different manufacturer’s fittings, spacers and sleeves are required to tighten up some of the sockets within the capsule. For the tool to perform at its best, the socket needs to be a snug fit into the funnel. In the 1016  kit, all the -16’s except Russell’s require the sleeve and a rear spacer. See the instructions in the case for the proper spacer number. Most of the -10’s and 12’s* will use a spacer. Not for use with Teflon-style hose. #1016

* -12 is a stainless washer.
 
 

Send to friend

: *
: *
: *
Type the characters you see in the picture:


*
The code is case-sensitive and must be entered exactly as above.

Customers also bought

ALUMINUM HYDRAULIC THROWOUT BEARING
$127.94
QUICKCAR IGNITION CONTROL PANELS
$30.95
Plattinum Products Floor Jack Holder-New Style
$71.35
Gates Heavy-Duty Radius Tooth HTD Cog belts, 30mm wide
$31.95
CTS Caster-Kit-Weld-On
$47.20
AutoMeter Angle Rings 3244
$27.99
$128.95
Used Stewart Water Pump Cartridge
$94.37
ARP Late GM Metric Wheel Studs
$39.95
 
The website uses cookies to allow us to better understand how the site is used. By continuing to use this site, you consent to this policy. Click to learn more. 
    

New Racing Parts and Equipment - Dirt and Asphalt Racing